Explorer Old Man Emu Front 2 inch Pin/Pin Shock – Single, GL2001

Description 1 x OLD MAN EMU Nitrocharger Plus Front Pin/Pin Shock, 2inch Part Number:- GL2001, Explorer Old Man Emu Front 2 Inch Pin/Pin Shock – Single Manufacturer:- Old Man Emu Weight:- 3.3Kg Fits:- Defender 90, 110, 130 / Discovery 1 / RRC Shock Dimensions  Shock Length open:- 593mm Shock Length closed:- 349mm Main Body Diameter:- 58mm Plastic Shroud Diameter:- 69mm Compatible turret part number – GL1056 These shocks can be fitted to vehicles: With a front Anti-roll bar, including our spacer – GL1275 Without an anti-roll bar From standard ride height Up to a 3″ suspension lift The GL2001 shocks are used as the front shock absorber in our Explorer 3″ Suspension Kit. This setup combines 2″ length front shocks with 3″ rear shocks, providing increased axle articulation while maintaining excellent road handling. This suspension kit gives the best of both worlds, on and off road use. For the full description, please see here – Gwyn Lewis Explorer 3″ Suspension Kit & Pricing Required components for longer travel shock absorbers GL1056, Front Turrets Extended brake hoses Spring retainers Spring relocators GL1171, Pin/Pin rear shock mounts Extended bump stops are required if fitting a spring lift. Protect the shock absorber from paint chips and rust by using this GL1249, Shock Absorber Protection Heat Shrink. These shocks are supplied fully assembled with bushes and our bush isolation washers fitted at each end. These isolation washers are important, as they help prevent wear to the shock absorber pin and allow for better flexibility. On later rear axles, the original cup washers are spot welded in by 4 spot welds. All 4 cup washers must be removed, as they restrict movement and can cause the shock pin to break off.  All our shocks come with new cup washers. Please fit them as shown in the instructions that come with each shock absorber. For an upgraded or replacement bush kit, using stainless steel washers and SuperPro Polyurethane bushes, please see here – GL1293 OME shock absorbers are designed to provide enhanced ride comfort and improved handling both on and off-road. Their finely tuned and balanced valving system is among the most advanced available. If a Defender 90 is very light and carries no additional weight, these GL2001 shocks can also be fitted to the rear to improve ride comfort, as they use softer valving. To fit them to the rear, GL1171 Pin/Pin Shock Mounts are required.